How to measure your bunkend canvas

PopupGizmos©

How to measure your bunkend canvas...

All measurements must be taken with your camper raised and the bunkends fully set-up.

With your bunkends fully set up, including having the top canvas support pole in place if this is a part of your camper, take the following measurements:

A. Side to Side: On the outside of your bunkend top, measure across the top from the point where the top canvas meets the side canvas. Measure the top at the widest side to side point. Be sure that your measurement tape lies flat on the canvas and follows any contours, such as the hump the inside support pole may create.

B. Front to back: On the outside of your bunkend top, measure along the top from where the canvas meets bottom edge of your camper's roof to the seam where the top canvas meets the side canvas at the end of the bunkend. Take this measurement at the center of your top canvas and be sure that your measurement tape lies flat on the canvas and follows any contours, such as the hump the inside support pole may create.

C. Slide-out: Measure your slide-out canvas top in the same manner as described above for the bunkends.

When producing your covers, a size allowance will be made to insure a good fit. As a result, please do not "fudge" your measurements by recording them longer or shorter than they actually are.

Record your measurements on the order form.

If you have any questions or concerns about measuring, please contact PopupGizmos for assistance.

Back to Solar Cover Page

All copy rights reserved. Copy right 2002-2007 PopupGizmos